Maytag MVWX600XW Use and Care Guide download pdf (Page 11)

REINSTALLING/USING WASHER AGAIN

To reinstall washer after non-use, vacation, winter storage,

or moving:

1. Refer to Installation Instructions to locate, level, and

connect washer.

2. Before using again, run washer through the following

recommended procedure:

To use washer again:

1. Flush water pipes and hoses. Reconnect water inlet hoses.

Turn on both water faucets.

2. Plug in washer or reconnect power.

3. Run washer through BULKY cycle to clean washer and

remove antifreeze, if used. Use only HE High Efciency

detergent. Use half the manufacturer’s recommended

amount for a medium-size load.

TROUBLESHOOTING

First try the solutions suggested here or visit our website at www.maytag.com/help

for assistance and to possibly avoid a service call.

If you experience

Possible Causes

Solution

Feet may not be in contact with the

oor and locked.

Front and rear feet must be in rm contact with oor, and

washer must be level to operate properly. Jam nuts must be

tight against the bottom of the cabinet.

Check oor for exing or sagging. If ooring is uneven, a 3/4"

(19 mm) piece of plywood under your washer will reduce sound.

See “Level the Washer” in Installation Instructions.

Load could be unbalanced.

Load dry items in loose heaps evenly around basket wall.

Adding wet items to washer or adding more water to basket

could unbalance washer.

Wash smaller loads to reduce imbalance.

Use Bulky cycle for oversized, non-absorbent items such as

comforters or poly-lled jackets.

See “Cycle Guide” and “Using Your Washer” in this Use and

Care Guide.

Check the following for

proper installation or

see “Using Your

Washer” section.

Washer may not be level.

Vibration or Off-Balance

Empty pockets before washing. Loose items such as coins

could fall between basket and tub or may block pump.

It may be necessary to call for service to remove items.

It is normal to hear metal items on clothing such as metal snaps,

buckles, or zippers touch against the stainless steel basket.

Objects caught in washer drain

system.

Clicking or metallic

noises

Noises- For normal operating sounds, go to www.maytag.com/help.

Gurgling or humming

It is normal to hear the pump making a continuous humming sound

with periodic gurgling or surging as nal amounts of water are

removed during the spin/drain cycles.

Washer may be draining water.

Humming

You may hear the hum of the sensing spins after you have started

the washer. This is normal. Sensing spins will take several minutes

before water is added to the washer.

The sensing light is on.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments

Maytag MVWX600XW Use and Care Guide Page 11

Comments to this Manuals

Related products and manuals for Washing machines Maytag MVWX600XW