Maytag MVWB880BW Installation Guide download pdf (Page 8)

4. Connect inlet hoses to washer

5. Check for leaks

Attach hot water hose to hot water inlet valve. Screw coupling

by hand until it is snug. Use pliers to tighten couplings an

additional two-thirds turn. Repeat with cold water inlet valve.

Both hoses must be connected for washer to work properly.

IMPORTANT: Do not overtighten or use tape or sealants on

valve when attaching to faucets or washer. Damage can result.

NOTE: To reduce risk of hose failure, replace the hoses every

5 years. Record hose installation or replacement dates for

future reference.

Periodically inspect and replace hoses if bulges, kinks,

cuts, wear, or leaks are found.

Turn on water faucets to check for leaks from faucet and at

washer connection. A small amount of water may enter washer.

You will drain this in a later step.

6. Secure drain hose

4.5"

(114 mm)

4.5"

(114 mm)

4.5"

(114 mm)

Laundry Tub Standpipe Wall

Secure drain hose to laundry tub leg, drain standpipe, or

inlet hoses for wall standpipe with cable tie (A). This will help

reduce the chance of drain water splashing on the oor.

Run water for a few seconds through hoses into a laundry

tub, drainpipe, or bucket to avoid clogs. Water should run

until clear. Check the temperature of the water to make

sure that the hot water hose is connected to the hot water

faucet and the cold water hose is connected to the cold

water faucet.

3. Clear water lines

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

No comments

Maytag MVWB880BW Installation Guide Page 8