Maytag MGDB835DC Installation Manual download pdf (Page 15)

1. Prepare to connect neutral

ground wire and neutral wire

Remove center terminal block screw (B). Remove neutral

ground wire (E) from external ground conductor screw (A).

Optional 3-wire Connection

You must verify with a qualied electrician that this grounding

method is acceptable before connecting.

Connect neutral ground wire

and neutral wire

Connect neutral ground wire (E) and neutral wire (white or

center wire) (C) of power supply cord or cable under center

terminal block screw (B). Tighten screw.

Connect remaining wires

Connect remaining wires to outer terminal block screws

Tighten screws.

Connect external ground wire

Connect a separate copper ground wire (G) from the external

ground conductor screw (A) to an adequate ground. Finally,

reinsert tab of terminal block cover into slot of dryer rear

panel. Secure cover with hold-down screw. Now, go to

“Venting Requirements.”

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

No comments

Maytag MGDB835DC Installation Manual Page 15