Maytag 11-06-00 User Manual

Browse online or download User Manual for Microwaves Maytag 11-06-00. Maytag 11-06-00 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 6
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
NOTES
Z Do not block air intake slots along bottom of oven.
INSTALLATION
1. Cut hole in cabinet to mount oven. Cutout in
cabinet should be level and straight.
NOTE: There are no provisions to level the unit
after it is installed. An oven that is not level could
cause poor baking results.
2. Install plywood floor as shown above.
3. Install top mounting bracket -- also refer to
template.(figure 3)
Top bracket mounting installation
instructions:
a. Before installing unit into the cabinet, open
microwave door, remove the two upper screws in
the trim kit holding the top mounting bracket (see
figure 1 next page) and set the bracket and
screws to the side.
b. Using scissors cut along the cut line on the
template (provided).
c. Find the center of the cabinet cutout.
d. Align the template center of opening” to the
center of the cabinet cutout making sure the top
of the cabinet cutout corresponds with the
template ”top of opening” indicator line. Tape may
be used to hold the template temporarily in place.
e. Locate and mark screw holes (A) at both
ends, 2 each side, of template.
f. Remove template and set it to the side.
g. Drill pilot holes into cabinet using 7/64” or
#35 drill bit.
h. Install top mount bracket (from step 3a) to
cabinet with the provided wood screws. (1/2” X 4)
8101P744-60
(11-06-00)
CAUTION
For European style cabinets (flush front) the required
clearance for operation of the oven door is minimum
spacing of 7/8 between the cutout and the door, hinge
or drawer of the cabinet.
Some built-in cabinets may not be wide enough, due
to their construction, to allow this installation.
COMBINATION
WALLOVEN CUTOUT
30 WALL OVEN DESCRIPTION
11-1/4 Dia. Conduit Access Hole*
25/8 Plywood Floor (Must Support 250 lbs.)
DIMENSIONS
in cm
A 30 MIN 76.20 MIN
B 24 MIN 60.96 MIN
C47+
1/16 119.38 + .16
D 24 MIN 60.96
E 28-1/2 +
1/16 72.39 + .16
F 47-5/8 120.97
G 29-3/4 75.57
H 24-7/16 62.07
I 4 to 20 10.2 to 50.8
* Hole must be cut as close to corner of cabinet as possible.
INSTALLATION
INSTRUCTIONS
Built-In 30 Electric
Combination Wall Ovens
403 WEST FOURTH STREET, NORTH
NEWT ON, IA 50208
Top bracket mounting installation instructions:
(continued)
i. Install and push unit in until trim frame engages with top
mount bracket.
j. Drive two screws that were removed in step (a) Do not
over tighten the screws.
4. Attach unit to the cabinet with 4 No. 8, flat head screws
supplied inside of envelope containing these instructions.
Pre--drill holes in cabinet for attachment screws using 1/8,
drill. Oven mounting holes are provided in side trim.
5. See instructions ”Electrical Connections” for electrical
hook--up.
6. See figure 2 next page for lower trim installation.
7. See User’s Manual for operating instructions.
Page view 0
1 2 3 4 5 6

Summary of Contents

Page 1 - Combination Wall Ovens

NOTESZ Do not block air intake slots along bottom of oven.INSTALLATION1. Cut hole in cabinet to mount oven. Cutout incabinet should be level and strai

Page 2 - ELECTRICAL CONNECTIONS

ELECTRICAL CONNECTIONSUnit to be properly circuit protected and wired according tolocal electrical code and National Electrical Code.It is advisable t

Page 3 - DE INSTALACIÓN

NOTASZ No obstruya las ranuras de entrada de aire de laparte inferior del horno.INSTALACIÓN1. Corte un orificio en el gabinete para montar el horno.El

Page 4 - ADVERTENCIA

CONEXIONES ELÉCTRICASEl circuito de la unidad debe estar protegido y cableadocorrectamente y de acuerdo con los códigos eléctricoslocales y con el Cód

Page 5 - Fours électriques mixtes

REMARQUESZ Ne pas bloquer les fentes de prise d’air le long du bas du four.MISE EN SERVICE1. Découper une ouverture dans l’armoire pour ymonter le fou

Page 6 - AVERTISSEMENT

RACCORDEMENT À L’ÉLECTRICITÉLe circuit utilisé par l’appareil doit être correctementprotégé et câblé conformément au code d’électricité localet au « N

Comments to this Manuals

No comments