Maytag MGC6536 User Manual download pdf (Page 10)

To Convert Appliance For Use

With Natural Gas

Electrical p o wer and gas must b e turned off

prior to conversion.

If this appliance has been converted for use with LP gas,

each of the following modifications must be performed to

convert the unit back to natural gas.

A. REPLACE ALL ORIFICE SPUDS.

1. Perform Steps 1 and 2 on page 8.

2. Perform Step 3 on page 8.

3. For Step 4: Locate the brass natural gas orifice

spuds that were originally installed in this appliance

before its conversion for use with LP gas. Observe

the number on each of the spuds and note the

correct burner location for each spud as shown in

figures 14 and 15.

FIGURE 14

Installation Of Natural Gas Orifice Spuds

5 BURNER MODEL (36² WIDE)

1.421.071.55

1.42 1.61

FIGURE 15

4 BURNER MODEL (30² WIDE)

1.42

1.07

1.42

1.61

4. Complete Steps 5, 6 and 7 on page 8 to complete

the installation of natural gas main spuds in their

correct locations.

5. Save the orifices removed from the appliance for

future use. They will be needed if this appliance is

again converted for use with LP gas.

B. INVERT CAP IN APPLIANCE PRESSURE

REGULATOR. (See figure 11).

With the appliance installed the appliance regulator

should be located as shown in either figure 3, 4 or 5

(pages 4, 5 & 6). Identify the type of appliance

regulator and follow the instructions in the appropriate

illustration.

C. RESET THE VALVES FOR NATURAL GAS

1. Light one burner, and set on low.

2. Remove the knob.

3. Remove the rubber grommets if necessary.

4. Locate the valve adjustment screw. If necessary

align hole in switch cover with adjustment screw.

See figure 12.

5. Insert a slender, thin-blade screwdriver into knob

hole and engage blade with slot in adjusting screw.

6. Starting from the LP position (see #5 on page 9,

under C. LOW FLAME ADJUSTMENT), turn the

screw counter clockwise until the flame stabilizes

and matches the pictured “low” setting on figure 13.

Proper adjustment will produce a stable, steady blue

flame of minimum size. The final adjustment should

be checked by turning the knob from high to low

several times without extinguishing the flame.

After Steps A, B and C have been completed, check

the appearance of each burner’s flame at the Hi and Lo

settings against figure 13. If the flames appear too

large or too small, make sure all steps were completed

correctly.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 32 33

Comments to this Manuals

No comments

Maytag MGC6536 User Manual Page 10

Comments to this Manuals

Related products and manuals for Hobs Maytag MGC6536