Maytag 50 lb. Single Pocket MDG50V Installation Manual download pdf (Page 50)

SECTION IX

PROCEDURE FOR FUNCTIONAL CHECK

OF REPLACEMENT COMPONENTS

1. Microprocessor Controller (Computer) Board

a. Upon completing installation of the replacement microprocessor controller (computer) board, reestablish

power to the dryer.

b. Start the drying cycle.

c. Verify that the motor(s) and the heat indicator dots, in the microprocessor controller (computer) light

emitting diode (L.E.D.) display are on. (Refer to the illustration below.)

d. Verify that the motors, heat, and door indicator lights on the back side of the microprocessor controller

(computer) board are lit. (Refer to the illustration below.)

1 2 ... 45 46 47 48 49 50 51 52

No comments

Maytag 50 lb. Single Pocket MDG50V Installation Manual Page 50