Maytag MGC6430 User's Guide download pdf (Page 8)

Care and Cleaning ................................,

Valve Adjustment

NOTE: All gas adjustments should be done by a qualified

servicer only.

The LOW setting should produce a stable flame when turning

the knob from HIGH to LOW. The flame should extend to the

outer edge of the lip of the burner cap on the LOW setting and

must be stable on all ports on the LOW setting.

To adjust: Operate burner on HIGH

Cou_r[E_CLOCKW¢_[

for about five minutes to preheat _o,_o_A_

burner cap. Turn knob to LOW; o,ooKw,SF,o_o_

FLAME SIZE

remove knob, and insert a small

screwdriver into the center of the

valve stem. Adjust the flame size by

turning adjustment screw in either

direction, while holding the valve

stem securely.

Flame must be of sufficient size to be stable on all burner ports.

If flame adjustment is needed, adjust ONLY on the LOW

setting. Never adjust flame size on a higher setting.

How to Remove Appliance for

Cleaning and Servfcing

When necessary, follow these procedures to remove

appliance for cleaning or servicing.

1, Shut offgas supply to appliance.

2. Disconnect electrical supply to appliance.

3. Disconnect gas supply tubing to appliance.

4, Remove screws that secure appliance to cabinet

Remove appliance from cabinet.

5. Reverse procedure to reinstall. Ifgas has been discon

nected check for gas leaks after reconnection. (Se_

installation instructions for gas leak test method.)

NOTE: A trained servicer should make the gas installa

tion, disconnection and reconnection of the gas supply t<

the appliance.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Maytag MGC6430 User's Guide Page 8