Maytag LPR1115ADW Installation Manual download pdf (Page 9)

-9-

GAS CONVERSION

To access the regulator from front of range, remove the

storage drawer or warming drawer.

To remove storage drawer: Pull out to the first stop

position. Lift up front of drawer and pull to the second

position, grasp sides and lift up and out to remove drawer.

To replace: Fit the drawer rollers onto the rails. Lift up

drawer front and gently push in to first stop position. Lift

up and continue to slide drawer to the closed position.

TO REMOVE WARMING DRAWER:

1. Empty drawer and pull out to its full open position.

2. Locate the black triangle levers on each side of the

drawer.

LEVER

3. Press the lever DOWN on the RIGHT side and lift the

lever UP on the LEFT side at the same time. Then pull

drawer out another inch.

4. Carefully pull the drawer all the way out holding on to

the sides, not the drawer front.

TO REPLACE WARMING DRAWER:

a. Pull the bearing glides to the front of the chassis glide.

(See picture below).

BEARING GLIDE

b. Align the glide on each side of the drawer with the glide

slots on the range. (See picture below).

c. Push the drawer into the range until levers “click”

(approximately 2²). Pull the drawer open again to seat

bearing glides into position. If you do not hear the

levers “click” or the bearing glides do not feel seated

removethedrawer and repeat stepsathrough c.This

will minimize possible damage to the bearing glides.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

No comments

Maytag LPR1115ADW Installation Manual Page 9