Read this before you start…TOOLS needed for installation:• Cutting knife• Channel lock• Nut driver•Level• Crescent wrenchProper installation is the re
ELECTRICAL120 Volt 60 Hz 15 AMP FuseIndividual branch circuit serving only thewasher is recommended.The washer is equipped with a power cord.NEVER USE
CABINET DIMENSIONSDRAIN FACILITYRecommended height of standpipe is 36”.The standpipe must be large enough to accepta 1-1/2 inch outside diameter drain
Remove parts and literature from inside of washer Start here…Step 2With the tub bl o ck in place and the lid tapedshut, lay corner posts on the floor,
tub. With the tub block in place, retape the lid. After insStep 7To prevent accidental dislodging, secure thedrain hose to the standpipe, inlet hose,
tallation is completed, be sure to remove tub block.Step 12Once the machine is level, tighten both frontleveling leg locking nuts with a wrench. Oncea
Comments to this Manuals