Maytag TM-1 User Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
If you will be gone for a month or less,
leave the controls at the usual settings.
During longer absences:
1. Remove all food.
2. Shut off the ice maker (if installed) and
the valve where you tapped into the
water line to supply the refrigerator.
3. Disconnect the refrigerator from the
electrical outlet.
4. Clean and dry the refrigerator
thoroughly.
5. Leave the doors open to prevent
odors.
When moving, follow steps 1-4 under
Vacations. In addition, remove and care-
fully pack any items that are easily
removable. Ship the refrigerator in an
upright position with the doors taped
shut.
Referto the chart onthe followingpage for
specific refrigeratorcleaning guidelines.
CLEANING UNDER THE
REFRIGERATOR
Yourrefrigeratorcan be rolledout for clean-
ingthe floor underneath.Raisethe leveling
screws if engaged (see page 2). Pull the
refrigeratorstraight out fromthe wall.
REPLACING A
LIGHT BULB
Always use a standard 40 or 60 watt
appliance bulb.
Refrigerator
There are two light bulbs located under
the top of the refrigerator compartment,
on either side of the Dual CoolTM control
housing.
> Carefully grasp the lightbulb by reach-
ing behind the bulb cover.
> Unscrew the light bulb and replace.
Freezer
The freezer light (select models) is locat-
ed on the back wall, near the upper right
corner.
To remove the bulb cover:
Grasp the top and bottom of the bulb
cover. Press in the areas of the attach-
ment tabs, applying enough pressure
to unhook the tabs. At the same time,
pivot the cover down and remove.
Unscrew the lightbulb and replace.
Replace the bulb cover by pivoting it
back into place and snapping the tabs
into the appropriate slots.
NO CLEANTM
COMMERCIAL-DUTY
CONDENSER
A clean condenser means more efficient
refrigerator operation. Thanks to the
unique design of the No CleanTM con-
denser there is no longer a need for rou-
tine condenser cleaning in normal home
usage surroundings.
Some operating environments may be
particularly dusty or greasy.In these situ-
ations, the condenser can be periodically
cleaned to insure maximum efficiency.
Locate the refrigerator away from heat
producing appliances such as the
range or dishwasher, heat vents and
direct sunlight.
Level the refrigerator and do not block
ventilation around the front grille.
Keep the freezer full to near capacity
so less cold air will escape during door
openings. When the freezer is less
than two-thirds full, place milk cartons
half full of water in the freezer.
Let hot dishes cool slightly before put-
ting into the refrigerator or freezer.
Cover liquids.
Wipe moisture from the outside of
containers before placing them into
the refrigerator.
Avoid opening the doors too often.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Comments to this Manuals

No comments