Maytag MLG32PD3 Installation Manual download pdf (Page 23)

G. GAS INFORMATION

It is your responsibility to have ALL plumbing connections made by a qualified professional to assure that the gas

plumbing installation is adequate and conforms with local and state regulations or codes. In the absence of such

codes,

ALL plumbing connections, materials, and workmanship must conform to the applicable requirements of

the National Fuel Gas Code ANSI Z223.1-LATEST EDITION, or in Canada, the Canadian Installation Codes

CAN/CGA-B149.1-M91 (Natural Gas) or CAN/CGA-B149.2-M91 (liquid propane [L.P.] Gas) or LATEST

EDITION.

IMPORTANT: Failure to comply with these codes or ordinances, and/or the requirements stipulated

in this manual, can result in personal injury and improper operation of the dryer.

The dryer and its individual shutoff valve must be disconnected from the gas supply piping system during any

pressure testing of that system at test pressures in excess of 1/2 psig (3.5 kPa).

The dryer must be isolated from the gas supply piping system by closing its individual manual shutoff valve

during any pressure testing of the gas supply system at test pressures equal to or less than 1/2 psig (3.5 kPa).

IMPORTANT: Failure to isolate or disconnect the dryer from supply as noted can cause

irreparable damage to the gas valve VOIDING THE WARRANTY.

WARNING: FIRE or EXPLOSION COULD RESULT.

1. Gas Supply

The gas dryer installation must meet the American National Standard...National Fuel Gas Code ANSI

Z223.1-LATEST EDITION, or in Canada, the Canadian Installation Codes CAN/CGA-B149.1-M91 (Natural

Gas) or CAN/CGA-B149.2-M91 (L.P. Gas) or LATEST EDITION. as well as local codes and

ordinances and must be done by a qualified professional.

NOTE: Undersized gas piping will result in ignition problems, slow drying, increased use of

energy, and can create a safety hazard.

The dryer must be connected to the type of heat or gas indicated on the dryer data label. If this information

does not agree with the type of gas available, DO NOT OPERATE THE DRYER. Contact the distributor

who sold the dryer or the manufacturer.

IMPORTANT: Any burner changes or conversions must be made by a qualified professional.

The input ratings shown on the dryer data label are for elevations up to 2,000 feet (610 meters), unless

elevation requirements of over 2,000 feet (610 meters) were specified at the time the dryer order was

placed with the factory. The adjustment or conversion of dryers in the field for elevations over 2,000 feet

(610 meters) are made by changing each burner orifice. If this conversion is necessary, contact the distributor

who sold the dryer or contact the MAYTAG COMPANY.

1 ... 22 23 24 ... 39

No comments

Maytag MLG32PD3 Installation Manual Page 23