Maytag MDB8969SDM User Manual download pdf (Page 10)

CYCLE RUNS TOO LONG NOTES:

■ Efficient dishwashers run longer to save water and energy. Cycle times may increase depending

on selections (See “Cycles and Options Descriptions” for estimated cycle times.)

■ A water heater setting of 120°F (49ºC) is best. The dishwasher will delay longer while heating

cooler water.

Try the Quick Wash cycle.

Run the hot water at a faucet close to the dishwasher before starting the cycle.

DISHWASHER NOT DRYING NOTE: Plastic and items with nonstick surfaces are difficult to dry because they have a porous

surface, which tends to collect water droplets. Towel drying may be necessary.

Use of rinse aid along with the Heated Dry and Sanitize option will provide the best drying and avoid

excess moisture in the dishwasher interior.

Proper loading of items can affect drying. (See specific loading instructions within this guide.)

Glasses and cups with concave bottoms hold water. This water may spill onto other items when

unloading.

■ Unload the bottom rack first.

■ Place these items on the more slanted side of the rack for improved results.

WILL NOT FILL Be sure the water is turned on to the dishwasher.

Check that the float is free from obstructions.

Check for suds in the dishwasher. If foam or suds are detected, the dishwasher

may not operate properly or may not fill with water.

WATER REMAINS IN THE TUB/

WILL NOT DRAIN

Be sure the cycle has been completed (the green light is on). If the cycle has not been completed, you

will need to resume the cycle by pressing START/RESUME and closing the door within 4 seconds.

If dishwasher is connected to a food waste disposer, be sure the knockout plug has been removed

from the disposer inlet.

Check for kinks in the drain hose.

Check for food obstructions in the drain or garbage disposer.

Check the house fuse or circuit breaker.

HARD WATER

(WHITE RESIDUE ON

DISHWASHER INTERIOR OR

GLASSWARE)

NOTE: Extremely hard water mineral deposits can cause damage to the dishwasher and make it

difficult to achieve good cleaning. A water softener is strongly recommended if the hardness is

15 grains or more. If a water softener is not installed, the following steps may help:

Use a commercial cleaner designed for dishwashers once per month.

Always use a rinse aid.

Always use a high-quality, fresh detergent.

Use a detergent booster/water softener additive designed for dishwashers.

ODORS NOTE: If the dishwasher is not used daily, you can run a rinse cycle with the partial load until a full

load is ready to run.

Run a vinegar rinse through the dishwasher by putting 2 cups (500 mL) of white vinegar in an upright

glass measuring cup in the lower rack. Run a normal cycle with the Heated Dry option turned off. Do

not use detergent.

The dishwasher may not be draining properly, see “WATER REMAINS IN THE TUB/WILL NOT DRAIN”

in “Troubleshooting.”

NOISY NOTES:

■ Surging sounds can occur periodically throughout the cycle while the dishwasher is draining.

■ Normal water valve hissing may be heard periodically.

■ A normal snap sound may be heard when the detergent dispenser opens during the cycle and

when the door is opened at the end of the cycle.

■ Improper installation will affect noise levels.

Be sure the filters are properly installed.

A thumping sound may be heard if items extend beyond the racks and interfere with the wash arms.

Readjust the dishware and resume the cycle.

PROBLEM SOLUTION

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Comments to this Manuals

No comments

Maytag MDB8969SDM User Manual Page 10

Comments to this Manuals

Related products and manuals for Dishwashers Maytag MDB8969SDM