Maytag MHN30PNAGW Specifications download pdf (Page 7)

INSTALLATIONINSTRUCTIONS

Excessive Weight Hazard

Use two or more people to move and install washer.

Failure to do so can result in back or other injury.

Max. packed weight:

PD model: 115 kg (253.53 Ib)

PN model: 111 kg (244.71 Ib)

Max. unpacked weight:

PD model: 111 kg (244.71 Ib)

PN model: 107 kg (235.89 Ib)

iMPORTANT: Position the washer so that the rear of the washer

is within approximately 900 mm (3 ft.) of its final location.

There are 4 shipping bolts in the rear panel of the washer that

support the suspension system during transportation. These bolts

also retain the power cord inside the washer until the bolts are

removed.

1. Keep the washer in the upright position while removing the

shipping bolts.

Shipping bolt --__ -'-_

Shipping bolt with plastic spacer

2. Using a 1/2" wrench, loosen each of the bolts.

3. Once the bolt is loose, move it to the center of the hole

and completely pull out the bolt, including the plastic spacer

covering the bolt.

4. Once all 4 bolts are removed, discard the bolts and spacers.

Then push the plug back into the back of the washer and pull

the power cord through the left opening of the rear panel and

close the hole with the attached cap.

5. Close the bolt holes with the 4 transport bolt hole plugs.

NOTE: If the washer is to be transported at a later date, call your

product distributor or installer. To avoid suspension and structural

damage, your washer must be properly set up for relocation by a

trained professional.

1. Select the plug that fits with the electric receptacle.

2. Assemble the plug into the end of the power cord.

3. Secure the power cord by seating the connection on the cord

lock.

4. Place the cord lock cover and push until it snaps.

5. Make sure the power cord connection is seated on the cord

lock and that the cord lock clamps correctly.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

No comments

Maytag MHN30PNAGW Specifications Page 7