Maytag MET3800XW Specifications download pdf (Page 17)

TROUBLESHOOTING – WASHER cont.

In the U.S.A.

In Canada

If you experience

Possible Causes

Solution

Normal washer operation. Door must be closed for washer to run.

Washer will pause during certain phases of cycle. Do not

interrupt cycle.

Washer spins the dry load for several minutes before ﬁlling to

determine if load is balanced. You may hear the hum of the spins.

This is normal.

Washer not loaded as

recommended.

Remove several items, rearrange load evenly in basket and add

detergent. Close door and press PUSH TO START.

Do not add more than 1 or 2 additional items after cycle has started

to avoid tightly packing or unbalancing.

First try the solutions suggested here or visit our website to possibly avoid the cost of a service call.

In U.S.A. www.maytag.com/help – In Canada www.maytag.ca.

Washer not performing as expected (cont.)

Use a cycle with a low spin speed. Cycles with lower spin speeds remove less water than cycles

with high spin speeds. Use the recommended cycle/speed spin for

your garment. To remove extra water in the load, select Spin. Load

may need to be rearranged to allow even distribution of the load in

the basket.

Empty pockets and use garment bags for small items.

Small items may have been caught

in pump or between basket and tub,

which can slow draining.

Washer not draining/

spinning, loads are

still wet

Washer not loaded as recommended. Tightly packing or unbalanced loads will not allow the washer to

spin correctly, leaving the load wetter than normal. See “Using Your

Washer” for loading recommendations.

Check plumbing for correct drain hose

installation. Drain hose extends into

standpipe farther than 4.5" (114 mm).

Check drain hose for proper installation. Use drain hose form

and securely attach to drainpipe or tub. Do not tape over drain

opening. Lower drain hose if the end is higher than 96" (2.4 m)

above the ﬂoor. Remove any clogs from drain hose.

Washer won’t run

or ﬁll, washer stops

working (cont.)

Too much detergent causing suds

to slow or stop draining and spinning.

Always measure and follow detergent directions for your load. To

remove extra suds, select Rinse and Spin. Do not add detergent.

Plug into a grounded outlet or reconnect power.

Do not use an extension cord.

Ensure there is power to outlet.

Reset a tripped circuit breaker. Replace any blown fuses.

NOTE: If problems continue, contact an electrician.

Check proper electrical supply.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Comments to this Manuals

No comments

Maytag MET3800XW Specifications Page 17

Comments to this Manuals

Related products and manuals for Washing machines Maytag MET3800XW