Maytag Stacked Washer/Dryer User Manual Page 1

14Alternate parts: (Not supplied with washer) Your installation may require additional parts. To order, please refer to toll-free numbers on the back

15LOCATION REQUIREMENTSProper installation is your responsibility. You will need: ! A water heater set to 120° F (49° C). ! A grounded electrical out

16Floor drain system requires a Siphon Break Kit (Part Number 285834), 2 Connector Kits (Part Number 285835), and an Extension Drain Hose (Part Numbe

17INSTALLATION INSTRUCTIONSNOTE: To avoid oor damage, set washer onto cardboard before moving it.48"(1.2 m)1. Move washerIt is necessary to remo

18Loosen bolts with a 15/32" (12 mm) wrench. Once the bolt is loose, move it to the center of the hole and completely pull out the bolt, includin

19Run water for a few seconds through hoses into a laundry tub, drainpipe, or bucket to avoid clogs. Water should run until clear.11. Clear water li

20LEVEL WASHERLeveling your washer properly reduces excess noise and vibration.Remove cardboard from beneath washer. Place a level on top edges of wa

2119. Plug into a grounded 3-prong outletCOMPLETE INSTALLATION CHECKLIST" Check electrical requirements. Be sure you have correct electrical