Maytag MGDX500XW User Manual download pdf (Page 14)

4. Using pliers, tighten the couplings with an additional two-thirds

turn.

NOTE: Do not overtighten. Damage to the coupling can result.

5. Attach

“Y” connector to brass male end of small hose. Screw on

coupling by hand until it is seated on connector.

6. One en

d of the long hose has a wire mesh strainer inside the

coupling. Attach this end to the “Y” connector.

7. Attach

washer cold inlet hose to other end of “Y” connector.

Screw on coupling by hand until it is seated on connector.

A. Inlet to cold water

8. Using pliers, tighten the couplings an additional two-thirds turn.

NOTE:

Do not overtighten. Damage to the coupling can result.

9. Attach

other end of long hose to fill valve at bottom of dryer back

panel. Screw on coupling by hand until it is seated on fill valve

connector.

10. Using pliers, tighten the coupling an additional two-thirds turn.

NOTE:

Do not overtighten. Damage to the coupling can result.

11. Check that the water faucets ar

e on.

12. Check for leaks around “Y” connector, faucet, and hoses.

LEVEL DRYER

Check the levelness of the dryer. Check levelness first side to side,

then front to back.

If the dryer is not level, prop up the dryer using a wood block. Use a

wrench to adjust the legs up or down and check again for levelness.

COMPLETE INSTALLATION

1. Check that all parts are now installed. If there is an extra part, go

back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Ch

eck the dryer’s final location. Be sure the vent is not crushed or

kinked.

5. Ch

eck that the dryer is level. See “Level Dryer.”

6. Remove the blue film

on the console and any tape remaining on

the dryer.

7. Wipe the dr

yer drum interior thoroughly with a damp cloth to

remove any dust.

8. Read “Dryer Use.”

Electric Models Only

9. F

or power supply cord installation, plug into a grounded outlet.

Gas Models Only

10. Check that gas supply is on.

11. Ch

eck for leaks.

Steam Models Only:

12. Be su

re the water faucets are on.

13. Ch

eck for leaks around “Y” connector, faucet, and hoses.

14. If you live in a har

d water area, use of a water softener is

recommended to control the buildup of scale through the water

system in the dryer. Over time, the buildup of lime scale may clog

different parts of the water system, which will reduce product

performance. Excessive scale buildup may lead to the need for

certain part replacement or repair.

All Model

15. Se

lect a Timed Dry heated cycle, and start the dryer. Do not select

the Air Only Temperature setting.

If the dryer

will not start, check the following:

■ Controls are set in a running or “On” position.

■ Start button has been pushed firmly.

■ Dryer is plugged into a grounded 3 prong outlet and/or

electrical supply is connected.

■ Household fuse is intact and tight, or circuit breaker has

not tripped.

■ Dryer door is closed.

This dryer automatically runs an installation diagnostic routine at the

start of its first cycle.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Comments to this Manuals

No comments

Maytag MGDX500XW User Manual Page 14

Comments to this Manuals

Related products and manuals for Washer dryers Maytag MGDX500XW