Maytag MEDB955FC Installation Manual download pdf (Page 24)

Set Pin

3. Install the plastic cover from the accessory kit into the space

where the lower hinge was removed. Place the plastic hinge

covers over the exposed hinges.

REVERSE STRIKE PLATE

1. Using a T20

screwdriver, remove the two screws securing

the strike plate and move the strike plate from the left side

of the dryer cabinet to the right side, securing it with the

removed screws.

2. Hang the door on the unit by placing set pin in dryer cabinet

hole and sliding door down. Using a Phillips screwdriver, install

screws 1 and 3 and then screws 2 and 4. Tighten all hinge

screws.

1. Using the screws you set aside, reinstall hinge B (removed

from the lower-left corner of the door) in the upper-right

corner. Tighten all screws.

2. Using the screws you set aside, reinstall hinge A (removed

from the upper-left corner of the door) in the lower-right

corner. Tighten all screws.

REINSTALL HINGES ON DOOR

3. Replace the door hinge covers.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

No comments

Maytag MEDB955FC Installation Manual Page 24