Maytag UXW6536BSS User Manual download pdf (Page 11)

RANGE HOOD CARE

Cleaning

IMPORTANT: Clean the hood and grease ﬁlters frequently

according to the following instructions. Replace grease

ﬁlters before operating hood.

Exterior Surfaces:

To avoid damage to the exterior surface, do not use steel wool

or soap-ﬁlled scouring pads.

Always wipe dry to avoid water marks.

Cleaning Method:

■ Liquid detergent soap and water, or all-purpose cleanser

■ Wipe with damp soft cloth or nonabrasive sponge,

and then rinse with clean water and wipe dry.

Metal Grease Filter:

1. Remove the ﬁlter by pulling the spring release handle

and then pulling down the ﬁlter.

2. Wash metal ﬁlter as needed in dishwasher or hot

detergent solution.

3. Reinstall the ﬁlter by making sure the spring release handles

are toward the front. Insert aluminum ﬁlter into upper track.

4. Push in spring release handle.

5. Push up on metal ﬁlter and release handle to latch into place.

Non-Vented (recirculating) Installation Filters:

The charcoal ﬁlter is not washable. It should last up to

6 months with normal use. Replace with Charcoal Filter

Kit Number W10412939.

To replace charcoal ﬁlter:

1. Remove metal grease ﬁlter from range hood.

See “Metal Grease Filter” in this section.

2. Bend spring clips away from metal grease ﬁlter.

3. Place charcoal ﬁlter into top side of metal ﬁlter.

4. Bend spring clips back into place to secure the

charcoal ﬁlter to the metal ﬁlter.

5. Replace metal grease ﬁlter. See “Metal Grease Filter”

in this section.

Replacing a Lamp

Turn off the range hood and allow the lamp to cool. To avoid

damage or decreasing the life of the new bulb, do not touch

bulb with bare ﬁngers. Replace bulb using tissue or wearing

cotton gloves to handle bulb.

If new lamps do not operate, make sure the lamps are inserted

correctly before calling service.

1. Disconnect power.

2. Use a Phillips screwdriver to remove screw from lamp cover.

3. Remove lamp cover and set lamp cover and the screw aside.

4. Remove bulb and replace with a new 120 volt, 40 watt

maximum E-12 bulb.

5. Replace lamp cover and reinstall screw.

6. Reconnect power.

A. Spring release handle

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments

Maytag UXW6536BSS User Manual Page 11

Comments to this Manuals

Related products and manuals for Hoods Maytag UXW6536BSS