Maytag UXT5536AAS User Manual download pdf (Page 9)

Install Range Hood

1. Remove the grease ﬁlters. See the “Range

Hood Care” section.

2. Remove mounting screws and lateral supports.

3. For vented installations:

■ Depending on your installation, remove either top

or rear rectangular vent knockout. If using round

vent, remove top rectangular knockout.

NOTE: Do not remove rectangular knockouts

if installation of range hood is to be non-venting

(recirculating).

■ Make sure damper pivot is nearest to top/back

edge of range hood.

■ Remove tape from damper ﬂap.

NOTE: The exhaust adaptor/damper can be

installed up to 1" (2.5 cm) on either side of the

hood center to accommodate off-center ductwork.

■ If using rectangular vent, attach rectangular damper/vent

connectors to the range hood using sheet metal screws.

■ If using round vent, attach vent transition piece

(purchased separately) to range hood top using

sheet metal screws.

NOTE: If the wall cap is directly behind the vent

connector, the dampers in the connector and

wall cap must not interfere with each other.

Remove the vent connector damper if they interfere.

4. Lift the range hood up under cabinet and determine

ﬁnal location by centering beneath cabinet. Mark on

the underside of cabinet the location of the 4 keyhole

mounting slots on the range hood. Set range hood

aside on a covered surface.

5. Use

" (3 mm) drill bit and drill 4 pilot holes as shown.

6. Install the 4 - #10 x

" mounting screws in pilot holes.

Leave about

" (6.4 mm) space between screw heads

and cabinet to slide range hood into place.

A. Lateral supports

B. Mounting screws

A. Vertical vent

B. Sheet metal screws

C. Hinge pin

D. Vent knockouts

E. Horizontal vent

A. Keyhole slot

A. Drill pilot hole

¹⁄₄"

(6.4 mm)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comments to this Manuals

No comments

Maytag UXT5536AAS User Manual Page 9

Comments to this Manuals

Related products and manuals for Hoods Maytag UXT5536AAS