Maytag MFW2055FRZ Use and Care Manual download pdf (Page 10)

Handle Installation

Parts Included: Handles (3)

Install Door Handles

1. Remove the handles from the packaging inside the

refrigerator.

NOTE: To avoid damaging the handles, place them on a

towel or other soft surface.

2. Place the keyhole slots in the handle over the shoulder

screws (preinstalled on the door). Apply firm pressure on the

handle to slide it down onto the shoulder screws.

NOTE: Do not push the handle toward the door; this can

damage the door. Apply only downward pressure.

3. Repeat the previous steps to install the adjacent door handle.

Install Drawer Handle

1. Place the keyhole slots in the handle over the shoulder

screws (preinstalled on the drawer). Slide the handle firmly to

the right to fully engage the shoulder screws in the keyhole

slots.

NOTE: Do not push the handle toward the drawer; this can

damage the drawer.

2. Save all instructions.

Remove the Handles

Refrigerator Door

■ Lift the handle directly upward, and pull it off of the door.

■ If necessary, use a Phillips screwdriver to remove the

shoulder screws from the door.

Freezer Drawer

■ Slide the handle to the left to disengage the keyhole slot from

the shoulder screws, and pull it off of the drawer.

■ If necessary, use a Phillips screwdriver to remove the

shoulder screws from the drawer.

Door Closing and Door Alignment

IMPORTANT: To comply with American Disabilities Act (ADA)

guidelines, fully retract the rollers into the cabinet to lower the

refrigerator.

Door Closing

The base grille covers the leveling screws and roller assemblies

located at the bottom of the refrigerator cabinet below the freezer

drawer. Before making adjustments, remove the base grille and

move the refrigerator to its final location.

1. Remove the base grille. Grasp the grille firmly and pull it

toward you.

2. Move the refrigerator to its final location.

NOTE: To allow the refrigerator to roll easier, raise the leveling

legs off the floor by turning the leveling screws

counterclockwise. The front rollers will be touching the floor.

3. So the doors will close easier, use a ¹⁄₄" hex driver to turn both

leveling screws clockwise. This will raise the front of the

refrigerator tilting it slightly downward to the rear. Turn both

leveling screws the same amount.

NOTE: Having someone push against the top of the

refrigerator takes some weight off the leveling screws. This

makes it easier to turn the screws.

4. Open both doors again to make sure they close as easily as

you like and that they stay closed. If not, tilt the refrigerator

slightly more to the rear by turning both leveling screws to the

right. It may take several more turns.

NOTE: To keep the refrigerator level, you should turn both

leveling screws the same amount.

A. Leveling screw

B. Front roller

¹⁄₄"

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 87 88

Comments to this Manuals

No comments

Maytag MFW2055FRZ Use and Care Manual Page 10

Comments to this Manuals

Related products and manuals for Fridges Maytag MFW2055FRZ