Maytag UXT4036AA User Manual download pdf (Page 5)

INSTALLING RANGE HOOD

WARNING

TURN OFF THE PROPER CIRCUIT AT THE SERVICE

ENTRANCE BEFORE WIRING THIS RANGE HOOD.

1. Run electric wiring through hole drilled in wall or cabinet. Split

wiring for 6" and install proper connector for type of wire used.

(FIG. 9)

FIG. 9

FIG. 11

6. Strip 1/2" of insulation foam wires. Connect white to white, black

to black, and green to prepared hole with green ground screw

provided. (FIG. 11)

2. Position hood so that:

a.) Wiring is routed through knockout opening. (FIG. 10)

b.) Large part of keyhole slots fit over hood mounting screws.

(FIG. 10)

c.) Damper/duct connector slides into ductwork.

(UXT3030AA, UXT3036AA, UXT4030AA, and UXT4036AA.

WARNING

ALL ELECTRICAL CONNECTIONS MUST BE IN

ACCORDANCE WITH LOCAL CODES, ORDINANCES, OR

NATIONAL ELECTRICAL CODE. IF YOU ARE UNFAMILIAR

WITH METHODS OF INSTALLING ELECTRICAL WIRING,

SECURE THE SERVICES OF A QUALIFIED ELECTRICIAN.

FIG. 10

3. Adjust hood so that hood front is flush with cabinet frame.

4. Tighten hood mounting screws firmly.

5. Fasten wiring to hood with proper electrical connector for type

of wiring being used.

7. Replace wiring box cover and screw. Make sure that all wiring is

safely contained inside.

8. Install light (75 Watt maximum) For easier installation, squeeze

plastic lens and remove it from hood. Remember to reinstall

lens (FIG. 12)

FIG. 12

9. Turn on power and check operation of fan and light. Make sure

that damper operates freely.

1 2 3 4 5 6 7 8

No comments

Maytag UXT4036AA User Manual Page 5