1W10617663C W10617664C-SPDRYER SAFETY ... 2INSTALLATION REQUIREMENTS ...
104-wire Direct Wire Connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit 3-wire connections. Un
113-wire Direct Wire ConnectionUse where local codes permit connecting cabinet-ground conductor to neutral wire. B5. Remove center screwRemove center
121. Prepare to connect neutral ground wire and neutral wireAEBRemove center terminal block screw (B). Remove neutral ground wire (E) from external g
13Venting RequirementsVENTINGExhaust hoods: Must be at least 12" (305 mm) from ground or any object that may obstruct exhaust (such as owers,
14Plan Vent SystemRecommended exhaust installationsTypical installations vent the dryer from the rear of the dryer. Other installations are possible.B
15Vent System ChartNumber of 90° turns or elbowsType of ventBox/louvered hoodsAngled hoods14320Rigid metalRigid metalRigid metalRigid metalRigid me
16Connect Vent1. Connect vent to exhaust outletUsing a 4" (102 mm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing ven
17Reverse Door Swing (Optional)29" Super Wide Side-Swing DoorPlace towel on top of dryer to avoid damaging the surface.NOTE: Magnetized screwdriv
18Remove the door catch, bezel, and plug from the inside of the inner door by squeezing and pulling/pushing them. Place the door catch, bezel, and plu
19TroubleshootingSee the Use and Care Guide or visit our website and reference Frequently Asked Questions to possibly avoid the cost of a service call
2DRYER SAFETY
09/14 Printed in U.S.A. W10617663C W10617664C-SP®/™ ©2014. All rights reserved.
4Location RequirementsYou will need: A location allowing for proper exhaust installation. See “Venting Requirements.” A separate 30 amp circuit.
5Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. D
6Electrical RequirementsIt is your responsibility: To contact a qualied electrical installer. To be sure that the electrical connection is adequa
7Electrical ConnectionPower Supply CordElectrical Connection Options1. Choose electrical connection typePower supply cord 4-wire receptacle(NEMA Type
8Direct WireABCDEF2. Remove terminal block coverBefore you start, disconnect power. Remove hold-down screw (D) and terminal block cover (A).A. Termin
93-wire Power Supply Cord ConnectionUse where local codes permit connecting cabinet-ground conductor to neutral wire. ABDCEFGA. 3-wire receptacle (NE
Comments to this Manuals