Maytag MT-AP510 Use and Care Guide download pdf (Page 4)

INSTALLATION REQUIREMENTS

Electrical Requirements

Electrical Connection

To properly install your air purifier, you must determine the type of

electrical connection you will be using and follow the instructions

provided for it here.

■ The air purifier should be connected to a 115 V, 60 Hz, 15- or

20-amp fused 3 prong grounded outlet.

■ The use of a time-delay fuse or time-delay circuit breaker is

recommended.

Location Requirements

■ You will need a level surface at least 6" (15.2 cm) from heat

sources such as ranges or heaters.

■ Do not block air openings or place air cleaner on a soft

surface such as a bed or sofa.

■ Operate indoors only.

AIR PURIFIER USE

NOTE: Before operating the air purifier, record the date of installation on the HEPA filter. Under normal conditions, the HEPA filter should

be replaced annually, and the pre-filter should be replaced every 3 months. To remove and replace either filter, see “Filter Replacement”

in the “Air Purifier Care” section.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

A. 6" (15.2 cm) minimum clearance

1 2 3 4 5 6 7 8 9 ... 19 20

No comments

Maytag MT-AP510 Use and Care Guide Page 4