Maytag MED7500YW Use and Care Manual

W10445417CPara obtener acceso al Manual de uso y cuidado en español, o para obtener información adicional acerca de su producto, visite: www.mayta

10DRYER DIMENSIONS233/8"(594 mm)331/4"(845 mm)231/4"(603 mm)39"(991 mm)Back view:31/4"(83 mm)113/4"(299 mm)27"(686

11Installation spacing for recessed area or closet installationn All dimensions show recommended and minimum spacing allowed. n Additional spacin

12ELECTRICAL REQUIREMENTSIt is your responsibility:n To contact a qualied electrical installer.n To be sure that the electrical connection is ade

13For direct wire installations:ELECTRIC INSTALLATIONFor power supply cord installations:Remove hold-down screw and terminal block cover.1. Choose ele

14Power supply cord strain relief:4-Wire Power Supply Cord ConnectionPower Supply Cord Connection4-wire receptacle (NEMA type 14-30R)4-prong plugSpade

153-wire receptacle (NEMA type 10-30R)3-prong plugSpade terminals with upturned endsRing terminalsUse where local codes permit connecting cabinet-grou

164-Wire Direct Wire ConnectionDirect Wire Connection1. Prepare your 4-wire cable for direct connection 1"(25 mm) 31⁄2"(89 mm) 5

171. Prepare your 3-wire cable for direct connection 1"(25 mm) 3½"(89 mm)2. Remove center screwBUse where local codes permit connecti

18Venting RequirementsVENTINGWARNING: To reduce the risk of re, this dryer MUST BE EXHAUSTED OUTDOORS.IMPORTANT: Observe all governing codes and ordi

19Plan Vent SystemChoose your exhaust installation typeRecommended exhaust installation:Vent System ChartNumber of 90° elbowsType of ventBox/louvered

2DRYER SAFETYELECTRIC DRYER TABLE OF CONTENTS DRYER SAFETY ...2OPERATING INSTRUCTIONS ...

20Install Vent System1. Install exhaust hood12" min.(305 mm)12" min.(305 mm)2. Connect vent to exhaust hoodInstall exhaust hood and use caul

212. Adjust leveling legsIf dryer is not level, prop up using a wood block, use wrench to adjust legs up or down, and check again for levelness. Once

22First try the solutions suggested here or visit our website at www.maytag.com/help for assistance and to possibly avoid a service call. If you exp

23Possible CausesSolutionThe dryer is located in a room with temperature below 45ºF (7ºC).Proper operation of dryer cycles requires temperatures above

24TROUBLESHOOTINGPossible CausesSolutionDryer Results (cont.)Stains on loadImproper use of fabric softener.Add dryer fabric softener sheets at the beg

25NOTES

26NOTES

27MAYTAG® LAUNDRY WARRANTYLIMITED WARRANTYFor one year from the date of purchase, when this major appliance is installed, operated, and maintained acc

6/12W10445417C Printed in U.S.A. ®/™ ©2012 Maytag. All rights reserved.ASSISTANCE OR SERVICEBefore calling for assistance or service, plea

3

4CONTROL PANEL AND FEATURESSTART BUTTONPress to start a cycle. Indicator light will glow to indicate the cycle has started. TEMPERATURE BUTTONThe Temp

5CYCLE GUIDE — SENSOR DRY CYCLESRegularHeavy cottons and denims More Dry NormalCottons and linens Normal Normal SyntheticsWhite and colorfast perm

63. Press POWERPress the POWER button to turn on the dryer. The indicator light will ash to indicate that the power is on.USING YOUR DRYER1. Clean th

75. Select the desired cycleSelect the desired cycle for your load. See the “Cycle Guide” for more information about each cycle. NOTE: Most loads may

8CLEANING THE LINT SCREENEvery load cleaningThe lint screen is located in the door opening of the dryer. The control panel has an indicator light to r

9INSTALLATION REQUIREMENTSTOOLS AND PARTSGather the required tools and parts before starting installation.Tools needed:Flat-blade screwdriver Wood blo