1AUTOMATIC DRYER INSTALLATION INSTRUCTIONSMISE EN SERVICE SÉCHEUSE AUTOMATIQUEINSTRUCCIONES DE INSTALACIÓN DE LA SECADORAAUTOMÁTICAThe installation, i
3-WIRE SYSTEM CONNECTIONS1. Loosen or remove center terminal block screw.2. Connect neutral wire (white or center wire) of power supply cord to the ce
117. Check All Connections:At this time, make sure all gas connections (on gas models), exhaust and electricalconnections are complete. Plug dryer in,
12ADDITIONAL INSTRUCTIONS FOR EXPORT MODELS(Not U.S. or Canada) Contact the distributor that sold the appliance or: MaytagInternational, 8700 W. Bryn
2Printed in U.S.A.. • Impreso en los Estados Unidos • Stampato negli Stati Uniti (revised 06/23/04) 22001460Proper installation is the responsibility
3IMPORTANT TO INSTALLERPlease Read The Following Instructions Carefully Before Starting To Install The Dryer. TheseInstructions Should Be Retained For
4MOBILE HOME INSTALLATIONThe installation of the dryer in mobile homes must conform to the Manufactured HomeConstruction and Safety Standard Title 24
5• Secure joints with duct tape. Do not use screws.• DO NOT EXHAUST DRYER INTO ANY WALL, CEILING, CRAWL SPACE OR ACONCEALED SPACE OF A BUILDING, GAS
6The static pressure in any exhaust system must not exceed 0.48 inches ofwater column, or be less than 0.This can be measured with the dryer running w
7If a power cord is not used and the electric dryer is to be permanently wired, the dryer mustbe connected to a grounded metal, permanent wiring syste
8• If the dryer is to be installed in a mobile home or an area where local codes do not permitgrounding through neutral, only a 4 conductor power cor
9INSTALLATIONParts and literature are packaged inside of dryer drum.To Install…1. Move dryer to an appropriate location for installation. Consider ins
Comments to this Manuals