1W10443041BW10443042B-SPTable of Contents DRYER SAFETY ... 2INSTALLATION REQUIRE
104. Connect remaining wiresConnect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into
11DIRECT WIRE CONNECTION1. Attach direct wire strain reliefCBA2. Attach direct wire cable to strain reliefDirect wire strain reliefUnscrew the removab
124. Connect neutral ground wire and neutral wireCEB6. Connect remaining wires5. Connect ground wireFAConnect ground wire (green or bare) (F) of dire
13You must verify with a qualied electrician that this grounding method is acceptable before connecting.OPTIONAL EXTERNAL GROUND FOR 3-WIRE CONNECTIO
14VENTING REQUIREMENTSVENTINGWARNING: To reduce the risk of re, this dryer MUST BE EXHAUSTED OUTDOORS.IMPORTANT: Observe all governing codes and ordi
15Optional exhaust installations:If you prefer, dryer may be converted to exhaust out right side, left side (all models except WED9051Y), or through b
16The “Vent System Charts” provide venting requirements that will help achieve best drying performance.NOTE: Bottom exhaust installations have a 90º
17Turn cold water off, remove and replace rubber washer1. Turn cold water faucet off and remove washer inlet hose.Check and see if rubber washer is in
18LEVEL DRYERLevel Dryer 1.Place level here Not Level LEVEL Not LevelCheck levelness of dryer from side to side.
19COMPLETE INSTALLATION CHECKLISTq Check that all parts are now installed. If there is an extra part, go back through steps to see what was skipped
2DRYER SAFETYIMPORTANT: When discarding or storing your old clothes dryer, remove the door.
20W10443041BW10443042B-SP© 2012 02/12All rights reserved Printed in U.S.A.
3INSTALLATION REQUIREMENTSTOOLS AND PARTSGather the required tools and parts before starting installation.Tools needed:Parts package is located in dry
4DRYER DIMENSIONSFront view:Side view: LOCATION REQUIREMENTSYou will need: A location allowing for proper exhaust installation. See “Venting Requ
5Door open view:Back view:61/4"(159 mm)281/8"(715 mm)31/2"(89 mm)14"(358 mm)ElectricNOTE: Most installations require a minimum of
6Closet Installation (stacked washer and dryer):1"(25 mm)1"(25 mm)51/2"(140 mm)24 in.2(155 cm2)48 in.2(310 cm2)3"(76 mm)3"(76
7INSTALL LEVELING LEGSPrepare dryer for leveling legs1. To avoid damaging oor, use a large at piece of cardboard from dryer carton; place under enti
82. Remove terminal block coverBefore you start, disconnect power. Remove hold-down screw and terminal block cover.ELECTRICAL CONNECTIONElectrical Con
9POWER SUPPLY CORD CONNECTIONPower supply cord strain relief:1. Attach power supply cord strain reliefDCBARemove the screws from a 3/4" (19 mm) U
Comments to this Manuals